Yes, there are a few postings out there about getting ipv6 routing running with XEN. But I’ll throw this online anyway since there are a few changes I had to make for it to work on my server. This text is intended for people who know their way around Linux and XEN so it will be a bit technical and won’t spell out every single step you have to make.
Most of the changes are based off scripts and information from BenV and wnagele (latter is interesting for me since I am also running XEN on a hetzner server). Have a look at the two links if anything is unclear. Now let’s start the fun 🙂
First of all we need IPv6 up and running on the host (dom0). Add the IP and gateway to your /etc/network/interfaces
This is what mine looks like:
iface eth0 inet6 static
address 2a01:4f8:100:1123::2
netmask 64
gateway 2a01:4f8:100:1120::1
pre-up ip -6 route add 2a01:4f8:100:1120::1 dev eth0
Check if the IP address is responding to the outside world (e.g. with wiberg.nu/iptools.php), if everything looks ok, proceed …
Now we need to enable a few things to get routing and neighbor discovery running on the host (dom0). Edit your /etc/sysctl.conf and add/change these 2 entries (and while you are at it, set them with “sysctl -w” too):
net.ipv6.conf.all.forwarding=1
net.ipv6.conf.all.proxy_ndp=1
So, your host should by now be online with ipv6 and soon be able to route packets to it’s guests. By default XEN will only take care of IPv4 when a guest is created, so here is a small patchfile that adds support for IPv6: xen-ipv6-vif-route.patch. The patch changes vif-route and vif-common.sh, while these files may be in different places depending on your distribution, /etc/xen/scripts/ is where they can commonly be found. Download the patch to the directory with the scripts to be changed and execute a “patch -p0 < xen-ipv6-vif-route.patch” (vif-common.sh gets a few new IPv6 functions, and iptables now won’t try to change stuff for IPv6 IPs. vif-route changes are: ndp is enabled for the vif device and the route/neighbor IPv6 settings are set)
So, now that the scripts know how to setup all our IPv6 needs, we need to add the IPv6 IP to our guest settings (.cfg file typically found in /etc/xen/). What we want to change is the “vif” setting. Add the IPv6 IP of the guest to the IPv4 IP (just the IP without the trailing /network, space separated form the IPv4 IP):
vif = [ 'mac=B1:A3:3F:25:11:B8, ip=2a01:4f8:100:1123::5 188.40.34.101' ]
Now you can create the guest(domU) and add the IPv6 IP to the /etc/network/interfaces of the guest if you haven’t so already (it uses the host (dom0) as the gateway).
iface eth0 inet6 static
address 2a01:4f8:100:1123::5
netmask 64
gateway 2a01:4f8:100:1123::2
Restart the networking on the guest (or reboot it) and you should now be able to ping the guest from the internet. See, easy wasn’t it 🙂